Brother PE-DESIGN NEXT Instruction Manual
68
Editing a Stitch Pattern
2.
Move the slider to select the desired
sensitivity. Click OK.
sensitivity. Click OK.
The stitch pattern is converted to grouped
manual punching data.
c
“Grouping/Ungrouping embroidery
patterns” on page 55.
patterns” on page 55.
Splitting off parts of a stitch
pattern
pattern
1.
Select a stitch pattern, and then click 1, then 2
to select the Split Stitch tool.
to select the Split Stitch tool.
All other stitch data disappear from the
display.
2.
Click in the Design Page at the point where
you want to start drawing the enclosing lines.
you want to start drawing the enclosing lines.
3.
Continue clicking in the Design Page to
specify each corner of the enclosure around
the area to be cut off.
specify each corner of the enclosure around
the area to be cut off.
4.
Double-click in the Design Page to specify the
section to be split off.
section to be split off.
Dividing stitch data by
color
color
Select the stitch pattern(s), and then click 1, then 2.
Dotted lines appear around each part of
the stitch data.
b
Memo:
The Normal setting should provide
satisfactory results in most cases, but
depending on the complexity of the pattern,
you may need to select a setting more
towards Coarse or Fine.
satisfactory results in most cases, but
depending on the complexity of the pattern,
you may need to select a setting more
towards Coarse or Fine.
a
Note:
The Stitch to Block command cannot be
used with some stitch pattern imported from
embroidery cards.
used with some stitch pattern imported from
embroidery cards.
1
2
b
Memo:
To remove the last point that was entered,
click the right mouse button.
click the right mouse button.
b
Memo:
The cutoff piece moves to the end of the
sewing order.
sewing order.
c
“Checking and Editing the Sewing
Order” on page 73.
Order” on page 73.
Before dividing
After dividing
1
2
XE8656-001.book Page 68 Monday, May 24, 2010 5:44 PM