Brother CM350 Installation Guide

7

After you have registered your machine with 
ScanNCutCanvas 
(http://ScanNCutCanvas.Brother.com/), they will be 
able to communicate via a wireless network 
connection to transfer data back and forth.

If setup is not completed correctly and an error 
message appears, see “Error codes/Error messages” 
on page 11.

Note

•

A computer or tablet that is connected to the 
network and can run ScanNCutCanvas is 
required.

•

Before continuing with this procedure, setup for 
the connection between your machine and 
wireless network must be completed. If your 
machine is not connected to the network, first 
follow the procedure in “Setting Up the Wireless 
Network Connection” on page 3.

After setting up the wireless network, one of the 
following screens will appear.

Memo

•

If you stopped the procedure after setting up 
the wireless network, touch the “Register” key 
beside “ScanNCut Online” on page 7 of the 
settings screen to start again with registering 
your machine with ScanNCutCanvas. The same 
screen that appeared immediately after setting 
up the wireless network will be displayed.

■ If the following screen appears:

Touch the “Next” key, and then continue with 
“Registering Your Machine with ScanNCutCanvas” on 
page 8.

■ If the following screen appears:

Touch the “Next” key, and then continue with 
“Activating Your Machine (Only on Machines 
Requesting Activation)” on page 7.

Activating Your Machine (Only on 
Machines Requesting Activation)

You will have to enter the activation code written on 
the “ScanNCut Online Activation Card” for your 
machine.

a

Note

• Depending on the model, the “ScanNCut Online 

Activation Card” may not be provided with your 
machine. In that case, it must be purchased 
separately.

Registering with ScanNCutCanvas for Your Machine