Alcatel-Lucent omnistack 6148 User Manual

Web-Based Management

3-6

Using the on-board Web agent, you can define system parameters, manage and 
control the switch, the connected stack and all its ports, or monitor network conditions. 
The following table briefly describes the selections available from this program.

System

Provides basic system description, including contact information.

Switch

Shows hardware/firmware version numbers, power status, and expansion 

modules in use.

IP

Includes boot state, IP address, and the maximum number of Telnet sessions 

allowed.

SNMP

Configures communities and trap managers; and activates traps.

Security

Sets password for system access. 

Upgrade

Downloads new version of firmware to update your system.

Configure

Saves the switch configuration to a file on a TFTP server. This file can be later 

downloaded to restore the configuration.

Address Table

Provides full listing of unicast addresses, sorted by address or VLAN.

STA

Enables Spanning Tree Algorithm; also sets parameters for switch priority, hello 

time, maximum message age, and forward delay; as well as port priority and 

path cost.

Bridge Extension

Displays/configures extended bridge capabilities provided by this switch, 

including support for traffic classes and VLAN extensions.

Priority

Configures default port priorities and displays queue assignments.

VLAN Management

Allows management access of the switch from all VLANs or only from a 

specified VLAN.

VLAN

Configures VLAN group members and other port-specific VLAN settings.

IGMP

Configures IGMP multicast filtering.

Port

Enables any port, sets communication mode to auto-negotiation, full duplex or 

half duplex, and enables/disables flow control. Also configures broadcast storm 

control and port security.

Mirror

Sets the source and target ports for mirroring.

Trunk

Specifies ports to group into aggregate trunks.

Statistics

Displays statistics on network traffic passing through the selected port.