Alcatel-Lucent omniaccess 6000 User Manual

Chapter 2

—Some cabinets require different screws which are not included. Verify 

that you use the correct screws or fasteners for your rack system.

If you have received your modules separately from the chassis, or wish to 
expand the system with additional modules, see Part 2 of this manual for 
specific instructions on installing each module.

—By adding modules, you are increasing the switch’s total power load. 

Depending on the modules installed, you may be required to add power sup-
plies to the switch and/or increase the capacity of your site’s electrical sys-
tems. For details, see 

Verify you understand the procedure and all precautions.

Before beginning, read the entire procedure. Verify you understand all the 
precautions in these steps as well as those on 

Verify that the installed power supplies can handle the switch’s 
power load.

The number of power supplies required for your Alcatel Wireless LAN Switch 
depends on the number and type of modules installed. See 

 for details.

Verify that your site’s electrical systems can handle the switch’s 
power load.

z

Each standard power supply (OWA-6000-PS200) is rated at 200 W total 
and is auto-ranging to accept 90-132/ 170-264 VAC, at 50 to 60 Hz.

z

Each optional power supply (OWA-6000-PS400) is rated at 400 W total 
and is auto-ranging to accept 85 to 264 VAC, at 50 to 60 Hz.

Depending on the switch’s total power load, you may be required to increase 
the capacity of your site’s electrical systems. See 

 for details.

—This procedure should be performed by a trained technician.