Alcatel-Lucent ap70 User Manual
AP Deployment
25
Chapter 3
1 Flip open the OmniAccess OAW-AP70 internal antenna.
2 Place the device on a sturdy table or shelf.
3 Orient the antennas.
For best performance, swivel the individual antennas or antenna array so that
they are oriented vertically. Once mounting is complete, connect the required
cables (see instructions on
they are oriented vertically. Once mounting is complete, connect the required
cables (see instructions on
Using the Built-In Mounting Slots
The keyhole-shaped slots on the back of the OmniAccess OAW-AP70 can be
used to attach the device upright to an indoor wall or shelf.
used to attach the device upright to an indoor wall or shelf.
To hang the OmniAccess OAW-AP70 upright using the mounting slots,
perform the following steps.
perform the following steps.
1 Install two screws in the wall or shelf as shown in
:
F
IGURE
3-2 Mounting Screw Specifications
If attaching the device to drywall, we recommend using appropriate wall
anchors (not included) as shown in
anchors (not included) as shown in
Figure 3-3
on
page 26
.
C
AUTION
—
Do not place the OmniAccess OAW-AP70 in any place where it could fall on
people or equipment. For more secure installation, use one of the optional mounting kits.
C
AUTION
—
Do not use the mounting slots to hang the OmniAccess OAW-AP70 from the
ceiling, sideways, or in any place where it could fall on people or equipment. For more
secure installation, use one of the optional mounting kits.
secure installation, use one of the optional mounting kits.
Screw/Nail Positions
(fastened to wall or shelf)
10 cm
(3 15/16")
3/32"
7/32"
3/16"
3/32"
clearance
from surface
2.4
mm
4.8
mm
1/16"
5/32"
5/32"
clearance
from surface
1.6
mm
4.0
mm
clearance
from surface
2.4
mm
clearnace
from surface
5.6
mm
Maximum
Minimum
Screw/Nail Dimensions