Alcatel-Lucent omniaccess User Manual
Configuring Redundancy
21
Chapter 4
6
Configure the Access Points to terminate their tunnels on the Virtual-IP
address. This can be done with greater flexibility and ease from the CLI.
The APs can be identified by their location code (building.floor.location)
with 0 being used as a wild card for any of the values. Thus a location code
of 10.0.0 would refer to all the APs in building 10. Refer to the AP provi-
sioning guide for directions on how to provision the APs with their location
codes.
The APs can be identified by their location code (building.floor.location)
with 0 being used as a wild card for any of the values. Thus a location code
of 10.0.0 would refer to all the APs in building 10. Refer to the AP provi-
sioning guide for directions on how to provision the APs with their location
codes.
N
OTE
—This command needs to be executed on the Master switch as only the
Master switch controls all APs in the network.
Use the steps in the table below to configure the “lms-ip” for a set of AP(s).
The example below shows how the steps shown above can be used to config-
ure the lms-ip for all APs in building 10:
ure the lms-ip for all APs in building 10:
Command
Purpose
Step 1
configure terminal
Enter the global configuration mode.
Step 2
ap location b.f.l
Use the location code value to select
set of AP(s) to configure.
set of AP(s) to configure.
Step 3
lms-ip ip-address
Configure the lms-ip for the selected
set of APs.
set of APs.