Alcatel-Lucent omniacces-voip gateway User Manual
VoIP Commands
Page 5-75
Command Usage
Specify time to wait to force caller to disconnect (channel timing). The call is automatically
terminated if the call originator does not hang up within the allotted time period after the
destination has hung up.
terminated if the call originator does not hang up within the allotted time period after the
destination has hung up.
Syntax Options
voice signaling hang up wait limit
voice signaling channel <
slot/port/startChannel-endChannel
> [no] hang up wait limit <
value
>
Definitions:
slot
slot
Specifies chassis slot number where VSM is installed, (e.g.,
2
).
port
Specifies physical port number on voice daughtercard, (e.g.,
1
).
startChannel
The first number in the range of voice channels (e.g.,
1
).
endChannel
The last number in the range of voice channels (e.g.,
30
).
♦ Syntax Note ♦
Be sure to separate the start and end range numbers with a
hyphen (e.g.,
1-30
).
no
Specifies no hang up wait limit (i.e., infinite).
value
Specifies time to wait to before disconnecting a call once the call originator has hung up
the phone, in seconds, from 0 ms to 65,534.
the phone, in seconds, from 0 ms to 65,534.
♦ Syntax Notes ♦
Do not use commas when entering the “no hang up wait limit”
(for example,
(for example,
65,534
will return a syntax error message).
Do not use
no
if entering a value.
A “no hang up wait limit” means the call remains connected
until the call originator hangs up the phone.
until the call originator hangs up the phone.
A “no hang up wait limit 100” or any other number of seconds,
is considered an invalid setting.
is considered an invalid setting.
Default:
The default setting is
The default setting is
no hang up wait limit
.
Command Examples:
voice signaling channel 2/1/1-12 no hang up wait limit
voice signaling channel 2/2/13-24 hang up wait limit 0
voice signaling channel 2/2/13-24 hang up wait limit 0