Alcatel-Lucent omniacces-voip gateway User Manual
VoIP Commands
Page 5-99
Command Usage
Specify E&M immediate start time to remain off-hook when congested.
Syntax Options
Remarks
The
voice signaling protocol
command must be set to the corresponding protocol type before
any commands for E&M (Wink Start, Immediate Start, and Delay Start Signaling), and FXS/
FXO (Loop and Ground Start) commands will take effect.
FXO (Loop and Ground Start) commands will take effect.
voice signaling emi glare report
voice signaling channel <
slot/port/startChannel-endChannel
> emi glare report <
value
>
Definitions:
slot
slot
Specifies chassis slot number where VSM is installed, (e.g.,
2
).
port
Specifies physical port number on voice daughtercard, (e.g.,
1
).
startChannel
The first number in the range of voice channels (e.g.,
1
).
endChannel
The last number in the range of voice channels (e.g.,
30
).
♦ Syntax Note ♦
Be sure to separate the start and end range numbers with a
hyphen (e.g.,
1-30
).
value
Specifies time period, in milliseconds from 0 to 60,000, (e.g.,
5000
), wherein if glare condi-
tion is detected, the line stays off-hook and generates a congestion tone.
♦ Syntax Note ♦
Do not use commas when entering the E&M immediate start-
time value in which a glare condition is reported and a conges-
tion tone is generated while off-hook (for example,
time value in which a glare condition is reported and a conges-
tion tone is generated while off-hook (for example,
5,000
will
return a syntax error message).
Default:
The default value is
The default value is
5000
milliseconds.
Command Examples:
voice signaling channel 2/1/1-12 emi glare report 5000
voice signaling channel 2/2/13-24 emi glare report 30000
voice signaling channel 2/3/1-30 emi glare report 60000
voice signaling channel 2/2/13-24 emi glare report 30000
voice signaling channel 2/3/1-30 emi glare report 60000