Alcatel-Lucent omniacces-voip gateway User Manual
VoIP Commands
Page 5-103
Command Usage
Specify time to ignore incoming digits after E&M delay start.
Syntax Options
Remarks
The
voice signaling protocol
command must be set to the corresponding protocol type before
any commands for E&M (Wink Start, Immediate Start, and Delay Start Signaling), and FXS/
FXO (Loop and Ground Start) commands will take effect.
FXO (Loop and Ground Start) commands will take effect.
voice signaling emd in digit ignore
voice signaling channel <
slot/port/startChannel-endChannel
> emd in digit ignore <
value
>
Definitions:
slot
slot
Specifies chassis slot number where VSM is installed, (e.g.,
2
).
port
Specifies physical port number on voice daughtercard, (e.g.,
1
).
startChannel
The first number in the range of voice channels (e.g.,
1
).
endChannel
The last number in the range of voice channels (e.g.,
30
).
♦ Syntax Note ♦
Be sure to separate the start and end range numbers with a
hyphen (e.g.,
1-30
).
value
Specifies the period of time after which E&M delay signal is completed before digits on
incoming calls are accepted, in milliseconds from 5 to 60,000, (e.g.,
incoming calls are accepted, in milliseconds from 5 to 60,000, (e.g.,
2500
).
♦ Syntax Note ♦
Do not use commas when entering the value for time to ignore
incoming digits after E&M delay start (for example,
incoming digits after E&M delay start (for example,
5,000
will
return a syntax error message).
Default:
The default value is
The default value is
2500
milliseconds.
Command Examples:
voice signaling channel 2/1/1-12 emd in digit ignore 2500
voice signaling channel 2/2/13-24 emd in digit ignore 30000
voice signaling channel 2/3/1-30 emd in digit ignore 60000
voice signaling channel 2/2/13-24 emd in digit ignore 30000
voice signaling channel 2/3/1-30 emd in digit ignore 60000