Alcatel-Lucent omniacces-voip gateway User Manual
VoIP Commands
Page 5-102
Command Usage
Specify maximum E&M delay start response to off-hook (dial tone) state.
Syntax Options
Remarks
The
voice signaling protocol
command must be set to the corresponding protocol type before
any commands for E&M (Wink Start, Immediate Start, and Delay Start Signaling), and FXS/
FXO (Loop and Ground Start) commands will take effect.
FXO (Loop and Ground Start) commands will take effect.
voice signaling emd in delay max
voice signaling channel <
slot/port/startChannel-endChannel
> emd in delay max[imum] <
value
>
Definitions:
slot
slot
Specifies chassis slot number where VSM is installed, (e.g.,
2
).
port
Specifies physical port number on voice daughtercard, (e.g.,
1
).
startChannel
The first number in the range of voice channels (e.g.,
1
).
endChannel
The last number in the range of voice channels (e.g.,
30
).
♦ Syntax Note ♦
Be sure to separate the start and end range numbers with a
hyphen (e.g.,
1-30
).
imum
Optional command syntax. Type either
max
or
maximum
in the command line.
value
Specifies the maximum duration of the delay signal response to the seize detect of incom-
ing calls on the M-lead, in milliseconds from 5 to 60,000, (e.g.,
ing calls on the M-lead, in milliseconds from 5 to 60,000, (e.g.,
2500
).
♦ Syntax Note ♦
Do not use commas when entering the maximum value for E&M
delay start response to off-hook (dial tone) state (for example,
delay start response to off-hook (dial tone) state (for example,
5,000
will return a syntax error message).
Default:
The default value is
The default value is
2500
milliseconds.
Command Examples:
voice signaling channel 2/1/1-12 emw in delay maximum 2500
voice signaling channel 2/2/13-24 emw in delay max 30000
voice signaling channel 2/3/1-30 emw in delay max 60000
voice signaling channel 2/2/13-24 emw in delay max 30000
voice signaling channel 2/3/1-30 emw in delay max 60000