Alcatel-Lucent omniacces-voip gateway User Manual
VoIP Commands
Page 5-225
Command Usage
Set RTP/RTCP (Real Time Protocol/Real Time Conferencing Protocol) port mode for voice
switching daughtercard H.323 gateway (dynamic/sequential).
switching daughtercard H.323 gateway (dynamic/sequential).
Syntax Options
Remarks
This command is used to set the port number assignment method for RTP and RTCP ports.
voice network h.323 rtp port mode
voice network card <
slot/card_number
} h.323 rtp port mode {dynamic | sequential}
Definitions:
slot
slot
Specifies the chassis slot number where VSM is installed, (e.g.,
2
).
card_number
Specifies the voice daughtercard position number, (e.g.,
1
).
dynamic
Assigns RTP/RTCP port numbers dynamically for H.323 gateway.
sequential
Assigns RTP/RTCP port numbers sequentially for H.323 gateway.
♦ Syntax Notes ♦
If the starting RTP/RTCP port mode for the gateway is set to
dynamic, then the RTP port base value is automatically set to
dynamic, then the RTP port base value is automatically set to
0
.
Starting RTP/RTCP port numbers are specified via the
h.323 RTP
port base
command.
Default:
The default setting is
The default setting is
dynamic
.
Command Example:
voice network card 2/1 h.323 rtp port mode dynamic
voice network card 2/2 h.323 rtp port mode sequential
voice network card 2/2 h.323 rtp port mode sequential