Alesis prolineardsp Owner's Manual
ProLinear DSP Quick Start Guide
(ENGLISH)
Connecting and Starting the ProLinear DSP
1. Turn the rear panel Input Level control to the Minimum position.
2. Connect the power cable to the speaker.
3. Connect the audio source’s output to the speaker with a TRS or XLR connector.
4. Turn on the audio source.
5. Turn on the ProLinear DSP.
6. After about five seconds, the front LCD panel will flash
2. Connect the power cable to the speaker.
3. Connect the audio source’s output to the speaker with a TRS or XLR connector.
4. Turn on the audio source.
5. Turn on the ProLinear DSP.
6. After about five seconds, the front LCD panel will flash
dSP
, followed by the software version number.
7. The speaker will enter Program mode (see the Front Panel picture).
8. With the audio source material playing, gradually turn up the Input Level control until the speaker is
8. With the audio source material playing, gradually turn up the Input Level control until the speaker is
playing the audio material at a comfortable level.
ProLinear DSP Rear Panel
The Front Panel
The ProLinear DSP front panel has a display and six buttons for operating the speaker.
The primary functions of the buttons are labeled in white. Edit mode functions (Value, Parameter and Band)
are labeled in blue.
The primary functions of the buttons are labeled in white. Edit mode functions (Value, Parameter and Band)
are labeled in blue.
VOLUME / PARAMETER Up
PROGRAM / VALUE Up
PAGE
SAVE / BAND
VOLUME / PARAMETER Down
PROGRAM / VALUE Down