Alesis prolineardsp Owner's Manual
Selecting a Program
Within Program mode, you can use the PROG buttons to select any one of the sixteen Programs:
PRESET
USER
1. Flat
1.
Warmth
2. Hi Fi (Smile)
2. Bass Boost
3. White Cone
3. Bass Cut
4. Faux Finnish
4.
Treble Boost
5. Studio Cube
5. Treble Cut
6. Boom Box
6.
AM Radio
7. BBC Dip
7.
Narrow
8. 80 Hz High Pass
8. Portable Radio
PROGRAM Down
PROGRAM Up
Editing a Program
When creating an equalization curve for the first time, you may want to begin with Program Preset 1 “Flat.” It
has no equalization applied.
Within each Program is a four-band parametric equalizer. There are three parameters for each Band:
has no equalization applied.
Within each Program is a four-band parametric equalizer. There are three parameters for each Band:
x
Frequency – The center frequency of the equalizer Band
The three Edit
mode screens
mode screens
x
Gain – The amount of boost or cut applied to the equalizer Band
x
Q – The width of the frequency range controlled by the Band
To edit a Program:
1. Push the PAGE button once to enter Edit mode.
2. Use the PARAMETER buttons to select a parameter to edit.
3. Use the VALUE buttons to change the value of the parameter.
4. Repeat steps 2 and 3 for all three parameters for that Band.
5. When you are done editing that Band, press the BAND button to
select another Band to edit.
6. Repeat steps 2 through 5 for each Band.
7. If you want to save your edited Program, see Saving a Program
below.
8. If you do not want to save your edited Program, press the PAGE
button to return to Program mode and select another Program.
Saving a Program
There are eight User Program locations available for saving your edited
Programs. To do this:
Programs. To do this:
PROGRAM Up
1. Press the SAVE button once. The LCD will begin to blink.
2. Use the PROG buttons to select the User Program location for the
2. Use the PROG buttons to select the User Program location for the
edited Program.
3. Press the SAVE button. The word SAVED will light for about two
seconds to let you know that the settings were saved.
PROGRAM Down
SAVE