Alpine ivx-m706r User Manual
10
-EN
Basic Operation
Turning Loudness On or Off
Loudness introduces a special low- and high-
frequency emphasis at low listening levels. This
compensates for the ear's decreased sensitivity to
bass and treble sound.
frequency emphasis at low listening levels. This
compensates for the ear's decreased sensitivity to
bass and treble sound.
NOTE
When an equalizer or digital sound processor is
connected, this function is inoperative.
connected, this function is inoperative.
1
Press and hold the rotary encoder for at least 2
seconds to switch between the Loudness On
and Off modes.
seconds to switch between the Loudness On
and Off modes.
Adjusting Source Signal Levels
If the difference in volume level between the CD/
MD player and FM radio is too great, adjust the
FM signal level as follows.
MD player and FM radio is too great, adjust the
FM signal level as follows.
1
Press the SOURCE button.
The main menu screen appears in the display.
The main menu screen appears in the display.
2
Press the
6
(SETUP) button.
The Setup mode screen is displayed.
3
Rotate the rotary encoder and select "FM
LEVEL." The Function Guide appears on the
display.
LEVEL." The Function Guide appears on the
display.
4
Press the
1
(LOW) or
2
(HIGH) button to make
the signal levels between the FM band and CD/
MD player closer.
MD player closer.
5
Press the FUNC (RETURN) button to return to
the main menu screen.
the main menu screen.
Adjusting the Volume/Bass/Treble/
Balance (Between Left and Right)/
Fader (Between Front and Rear)
Balance (Between Left and Right)/
Fader (Between Front and Rear)
1
Press the rotary encoder repeatedly until the
mode you wish to adjust is obtained. Each press
changes the modes as follows:
mode you wish to adjust is obtained. Each press
changes the modes as follows:
→
BAS.
→
TRE.
→
BAL.
→
FAD.
→
VOL.
The volume level can be adjusted at any time by
just rotating the rotary encoder.
just rotating the rotary encoder.
NOTE
When the subwoofer mode is ON, its level may also be
adjusted.
adjusted.
2
Rotate the rotary encoder to set to the desired
sound within 5 seconds after selecting the mode.
sound within 5 seconds after selecting the mode.
NOTE
If the rotary encoder is not turned or pressed within 5
seconds after selecting the BAS. (Bass), TRE. (Treble),
BAL. (Balance), or FAD. (Fader), the unit automatically
defaults back to the VOL. (Volume) mode.
seconds after selecting the BAS. (Bass), TRE. (Treble),
BAL. (Balance), or FAD. (Fader), the unit automatically
defaults back to the VOL. (Volume) mode.
Audio Mute Function
Activating this function will instantly lower the
volume level by 20 dB.
volume level by 20 dB.
1
Press the MUTE button to activate the MUTE
mode. The audio level will decrease by about
20 dB.
Pressing the MUTE button again will bring the
audio back to its previous level.
mode. The audio level will decrease by about
20 dB.
Pressing the MUTE button again will bring the
audio back to its previous level.
(IVX-M706 .... with MD built-in
CVA-1006R ... without MD built-in)
CVA-1006R ... without MD built-in)
SOURCE
MUTE
1 2
6
FUNC
Rotary encoder
SOURCE
Rotary encoder
MUTE
1 2
FUNC
6
(IVX-C806)