ASUS mypal a600 User Manual
Avolites Pearl 2000 Operators Manual - page
100
P2000MAN.DOC 19/10/99 17:59
•
Put the Channel you want Reduced up at FULL.
•
Go to the REDUCE FIXTURE INTENSITY Bank.
All Preset Faders now
operate as Reduction Faders.
•
Match the output level with the Intensity Channel by bringing the
Reduction Fader to Full also
. If it is already at Full, bring it down to zero, the back
up
.
•
Bring the Reduction Fader down to limit the output to the desired level.
9.10 Programming in BLIND mode
9.10.1 Entering Blind Mode
•
Turn the Key to Program.
Puts you in LIVE PROGRAM MODE menu.
•
Press Softbutton F [PRESS FOR BLIND MODE].
Puts you in BLIND
PROGRAM MODE menu.
When in Blind Mode the Programmer and the Preset Faders are
disconnected from the output so you can build or edit Memories and Chases
without your programming being seen on stage.
disconnected from the output so you can build or edit Memories and Chases
without your programming being seen on stage.
Programming is identical to Live Program Mode except your changes cannot
be seen on the output.
be seen on the output.
⇒
When you enter Blind Mode, Channels already in the Programmer stay
there. It may therefore be desirable to CLEAR the programmer on first
entering Blind Mode, or Channels in the Programmer may be included in
your programming.
entering Blind Mode, or Channels in the Programmer may be included in
your programming.
9.10.2 Exiting Blind Mode
•
Again press Softbutton F [PRESS FOR LIVE MODE]
Puts you in LIVE
PROGRAM MODE menu.
When you exit Blind Mode Channels in the Programmer are cleared and the
programmer is reloaded with any Channels that were in the programmer
before Blind Mode was selected.
programmer is reloaded with any Channels that were in the programmer
before Blind Mode was selected.
This means that entering and exiting Blind Mode does not affect what is
seen on stage, and you can Blind Program in the middle of a show if
necessary.
seen on stage, and you can Blind Program in the middle of a show if
necessary.
⇒
To keep the Programmer contents before you return to Live mode you
should record a Memory, which you can later INCLUDE. See Section 9.7
The INCLUDE button.
The INCLUDE button.
9.10.3 To alter a Memory without changing the look on stage
•
Turn the Key to Program.
Puts you in LIVE PROGRAM MODE menu.
•
Press Softbutton F [PRESS FOR BLIND MODE].
Puts you in BLIND
PROGRAM MODE menu.
•
Include the Memory to be altered.(See section 9.7 The INCLUDE
button)
•
Edit the Memory as required.
•
Save the Memory in the usual way.