ASUS mypal a600 User Manual
Avolites Pearl 2000 Operators Manual - page
138
P2000MAN.DOC 19/10/99 17:59
16. The Stage Remote
The Stage Remote is a small hand held DMX controller connected to the
desk. It is optional, and can be ordered from Avolites by its zappy title, Part
number 30-12-0001.
desk. It is optional, and can be ordered from Avolites by its zappy title, Part
number 30-12-0001.
The desk and the Remote are linked via a cable with a 25 pin D type
connector on each end. This may be plugged into whichever end of the
Stage Remote is most convenient and may be plugged in and unplugged at
any time.
connector on each end. This may be plugged into whichever end of the
Stage Remote is most convenient and may be plugged in and unplugged at
any time.
From the Remote you may control a DMX Channel, a Handle or a Memory.
You can also step through a Chase.
You can also step through a Chase.
16.1 Configuring the Stage Remote
•
Turn the Key to Program
.
If you are already in Program, turn the Key to
Run, then back to Program.
•
In the User settings menu, set Option 10 to REMOTE CONTROL
. The
remote control will not function correctly unless this is done
.
•
Connect up the Stage Remote as described above.
•
Press the blank white key on the bottom left hand corner of the Remote
.
The LED’s on the remote will flash.
•
On the remote press EXIT followed by 111
. The LED’s on the remote will flash
again to show the Remote is enabled.
From the remote you may now call up DMX Channels.
The remote only functions when the key is in PROGRAM mode.
16.2 To call a single DMX channel
•
Press DIM.
Its LED lights up.
•
Select the DMX number on the remote.
•
Press the AT% button.
•
Press a number form 1 to 9 to set the level or press the AT% button
again for 10 (100%).
For example, to turn DMX Channel 24 on to 70% press :
DIM 2 4 AT% 7.
DIM 2 4 AT% 7.
To turn DMX Channel 100 on to Full press :
DIM 1 0 0 AT% AT%.
DIM 1 0 0 AT% AT%.
To enable access to DMX Channels on all four outputs, they are numbered
thus :
thus :