ASUS mypal a600 User Manual
Avolites Pearl 2000 Operators Manual - page
61
P2000MAN.DOC 19/10/99 17:59
6.13 Recording and recalling Memories on the Graphics Tablet and Stage
Remote
Remote
Memories can be recorded directly from the Graphics Tablet. See Section
15.9.3 Record Memory in the Graphics Tablet chapter.
15.9.3 Record Memory in the Graphics Tablet chapter.
Memories can be replayed directly from the Stage Remote. See Section 16.4
Using the Remote to recall a Memory in the Stage Remote chapter.
Using the Remote to recall a Memory in the Stage Remote chapter.
6.14 Help and Hints
Problem : Memory does not replay after programming.
Solution : Press the CLEAR button, or turn the Key to Run.
Solution : Press the CLEAR button, or turn the Key to Run.
Problem : Programmed Memories have disappeared.
Solution : Check that you are on the correct Roller Page and Facet.
Solution : Check that you are on the correct Roller Page and Facet.
Problem : Some HTP Channels do not replay.
Solution : Check that they have not been reduced in the Reduction bank.
See Section 9.9 Reduction Faders.
Solution : Check that they have not been reduced in the Reduction bank.
See Section 9.9 Reduction Faders.
Problem : Some Channels on Moving Lights do not replay.
Solution : They probably have not been recorded. If you are using Record
by CHANNEL then you must edit each channel that is to be recorded to put
it in the Programmer. This means that you must access each one and do
something to it, even if it is only reasserting the level it is currently at. See
Section 6.1 Recording Modes.
Solution : They probably have not been recorded. If you are using Record
by CHANNEL then you must edit each channel that is to be recorded to put
it in the Programmer. This means that you must access each one and do
something to it, even if it is only reasserting the level it is currently at. See
Section 6.1 Recording Modes.
Problem : The Presets, Wheel and Tablet do not output to the stage.
Playbacks work correctly.
Solution : Check you have not selected BLIND mode. See Section 9.10
Programming in BLIND mode.
Playbacks work correctly.
Solution : Check you have not selected BLIND mode. See Section 9.10
Programming in BLIND mode.