Audiovox 128-6586 User Manual

Use the remote control to make the following changes to speaker balance. Press the SOUND button to select
the desired speaker and press NEXT or PREV button to adjust the channel level.
Notes :
1. If you do not press any button within a few seconds, the display will return to normal.
2. Every press on the SOUND button will change the menu cyclically as below:

Press the SOUND button repeatedly to select an equalization mode (BASS, MIDDLE, TREBLE). Press the
NEXT or PREV button to adjust the level.
•   BASS: Adjust  the low range of sounds.
•   MIDDLE: Adjust the middle range of sounds.
•   TREBLE: Adjust the high range of sounds.
Press the SOUND button until the menu “ MODE LINE ” appears. Press the NEXT or PREV button to switch
between “ MODE LINE ” and “ MODE RF ”. The “ MODE LINE” and “ MODE RF ” are only effective when Dolby
Digital signal is input in AV IN mode.
•   MODE LINE: Enables dialogue normalization without compression scaling.
•   MODE RF: Causes dialogue to reproduce at a level that compares well with quality television broadcasts

and premium movie channels with fully compression scaling.

NOTE:
•  Bass, middle and treble control the sound from the front left and right speakers.

Press the SOUND button repeatedly to select the delay time of the center speaker and the rear speakers.
Press the NEXT or PREV button to adjust the delay time (millisecond).
•   P DELAY: Set the delay time of the rear speakers for Dolby Pro Logic mode.
•   D DELAY: Set the delay time of the rear speakers for Dolby Digital mode.
•   C DELAY: Set the delay time of the center speaker.

8

Notes:
1. This unit supports three digital input modes:

• Dolby Digital 5.1ch. In this mode, press the SURROUND button on the remote control to select between

Dolby D (5 CH.) and Downmix (2 CH.).

• Dolby Digital 2.0ch. In this mode, press the SURROUND button to select among Dolby D (2 CH.), 3

STEREO (3 CH.) and DOLBY PRO LOGIC (4 CH.).

• PCM. In this mode, press the SURROUND button to select among Dolby D (2 CH.), 3 STEREO (3 CH.)

and DOLBY PRO LOGIC (4 CH.).

2. When analog signal is input, Press the SURROUND button to select among STEREO, 3 STEREO and

DOLBY PRO LOGIC.