3com 520 User Manual
Quick Configuration
1-27
Connecting to the Internet or a PPP Router
To connect to an Internet router or to a router using
Point-to-Point Protocol (PPP), enter
IN
at the
command prompt on the Quick Configuration screen
to display the screen illustrated in
Figure 1-14
Connecting To The Internet Or PPP Router
Complete the fields on this screen as follows:
If you are connecting to the Internet, your service
provider will be able to give you the correct values for
each of these fields.
If you are connecting to a remote PPP router, check
with the system administrator of the remote network
for the correct values for these fields.
Name of your Internet Provider or remote site
Type the name of your Internet service provider or of
the remote unit that connects to the remote IP network.
ISDN Number of the remote unit
Type the ISDN
number of the remote unit that connects to the
remote IP network.
Call Type
Set the Call Type for each ISDN number.
Use
64k Unrestricted
for Euro ISDN lines. Use
56k V.110
or
56k_restricted
in the USA depending on the
requirements of your ISDN service provider.
IP Address of this unit’s LAN
Type the IP address of
this unit. This the address you entered on the Name
screen.
IP Mask of this unit’s LAN
Type the IP subnet mask
you entered for this unit on the Name screen. See
for more information about subnet masks.
Rc.bk : RC01.FRM Page 27 Thursday, July 10, 1997 9:53 AM