3com WX2200 3CRWX220095A User Manual

C

HAPTER

 10: C

ONFIGURING

 MAP A

CCESS

 P

OINTS

To enable local switching for MAP 7, type the following command:

WX# set ap 7 local-switching mode enable
success: change accepted.

To apply a VLAN profile to a MAP to use with local switching, use the 
following 

command:

set ap apnumber local-switching vlan-profile profile-name

When a VLAN profile is applied to a MAP, traffic for the VLANs specified 
in the VLAN profile is locally switched by the MAP instead of being 
tunneled back to a 

WX switch.

If local switching is enabled on a MAP, but no VLAN profile is 
configured, then a default VLAN profile is used. The default VLAN 
profile includes a single VLAN named default that is not tagged

.

When applying a VLAN profile causes traffic that had been tunneled to a 
WX switch to be locally switched by MAPs, or vice-versa, the sessions of 
clients associated with the MAPs where the VLAN profile is applied are 
terminated, and the clients must re-associate with the MAPs.

To specify that MAP 7 use VLAN profile locals, type the following 
command:

WX# set ap 7 local-switching vlan-profile locals
success: change accepted.

To clear the VLAN profile that had been applied to a MAP, use the 
following 

command:

clear ap ap-number local-switching vlan-profile

When the VLAN profile is cleared from the MAP, traffic that had been 
locally switched is tunneled to a WX switch.

When clearing a VLAN profile causes traffic that had been locally 
switched by MAPs to be tunneled to a WX switch, the sessions of clients 
associated with the MAPs where the VLAN profile is applied are 
terminated, and the clients must re-associate with the MAPs.