3com WXR100 3CRWXR10095A User Manual

Table 9 summarizes parameters that apply to individual MAPs, including 
dual-homing parameters. (For information about parameters for 
individual radios, see “Configuring a Radio Profile” on page 240 and 
“Configuring Radio-Specific Parameters” on page 246.)

Table 9   Global MAP Parameters

Based on the port or 
Distributed MAP connection 
number. For example:

„

MAP01

„

DAP01

MAP name.

Setting a MAP’s bias on a 
WX switch to high causes the 
switch to be preferred over 
switches with low bias, for 
booting and managing the 
MAP. 

Note: Bias applies only to 

WX

 switches that are 

indirectly attached to the 
MAP through an 
intermediate Layer 2 or Layer 
3 network. A MAP always 
attempts to boot on MAP 
port 1 first, and if a WX 
switch is directly attached on 
MAP port 1, the MAP boots 
from it regardless of the bias 
settings.

None

Named set of MAPs. MSS 
load-balances user sessions 
among the access points in 
the group.

Automatic upgrade of boot 
firmware.

LED blink mode — blinking 
11a LED (AP2750) or health 
and radio LEDs (MAP-xxx) 
make the MAP visually easy 
to identify.