3com WXR100 3CRWXR10095A User Manual

C

HAPTER

 10: C

ONFIGURING

 MAP A

CCESS

 P

OINTS

To disable radio 1 on port 6 without disabling the other radios using radio 
profile rp1, type the following command:

WX1200# set ap 6 radio 1 radio-profile rp1 mode disable

(To disable or reenable all radios that are using a radio profile, see 
“Disabling or Reenabling All Radios Using a Profile” on page 250.)

You can disable or reenable radios on a radio profile basis or individual 
basis. You also can reset a radio to its factory default settings.

(To disable or reenable radios when assigning or removing a radio profile, 
see “Assigning a Radio Profile and Enabling Radios” on page 249.)

To disable or reenable a MAP radio, use the following command:

set ap apnumber radio {1 | 2} mode {enable | disable}

To disable radio 2 on port 3 and 6, type the following command:

WX1200# set ap 3,6 radio 2 mode disable
success: change accepted.

To disable or reenable all radios that are using a radio profile, use the 
following command:

set radio-profile name [mode {enable | disable}]

The following command enables all radios that use radio profile rp1:

WX1200# set radio-profile rp1 mode enable
success: change accepted.

The following commands disable all radios that use radio profile rp1, 
change the beacon interval, then reenable the radios:

WX1200# set radio-profile rp1 mode disable
success: change accepted.
WX1200# set radio-profile rp1 beacon-interval 200
success: change accepted.
WX1200# set radio-profile rp1 mode enable
success: change accepted.