3com wx3010 ac poe 8get 2sfp User Manual
3-18
Connecting the Power Cables
Connecting AC Power Cable
The power cords may vary with different standards of different countries, so you may need to select a
bail latch as needed.
bail latch as needed.
Follow these steps to connect the AC power cable:
Step1
Verify that the chassis PGND is correctly connected to the earth ground.
Step2
Install the bail latch onto the device and pivot the bail latch up.
Step3
Plug one end of the power cable to the AC power receptacle on the rear panel of the chassis and plug
the other end to the AC power source.
the other end to the AC power source.
Step4
Place the bail latch over the AC power cable to secure the plug in place.
Figure 3-27
Connect the AC power cable
(1) Rear panel
(2) Bail latch holder
(3) Bail latch
(4) AC power cable
Step5
Check the RPS LED on the front panel of the device. Solid green indicates that the AC power input is
normal.
normal.
z
Since the WX3010 and WX3008 do not have the RPS LED, blinking green of the PWR LED
indicates that the AC power input is normal. For details about LED status, refer to LEDs on page
1-6.
indicates that the AC power input is normal. For details about LED status, refer to LEDs on page
1-6.
z
The bail latch prevents the power cable from accidentally falling off.