3com TR User Manual

This section provides instructions for resetting the 
Switch 2000 TR.

Because some configurable parameters require that 
you reset the Switch 2000 TR after making changes, it 
is important to understand the reset procedure before 
proceeding.

You have four different ways to reset the Switch 2000 
TR:

■

VT100 Console

■

LCD Console

■

Reset button

■

Power cycle

The Switch 2000 TR must be reset after making cer-
tain changes using the VT100 interface. You may 
make more than one change before committing them 
to memory by resetting.

To reset the Switch 2000 TR from the VT100 interface 
when you have made changes, take these steps:

Select RESET from the Switch 2000 TR Main Menu.

The Switch 2000 TR TR Reset screen appears. See 
Figure 3-15.

Select OK to confirm the reset or CANCEL to stop the 
reset. If you select OK you will be prompted to con-
firm again.

The Switch 2000 TR resets.

Figure 3-15   Switch 2000 TR Reset Screen

When you make certain parameter changes using the 
front panel LCD console, you must commit them to 
system memory by performing a reset.

To reset the Switch 2000 TR using the LCD, proceed 
as follows:

Press [Up or Down Arrow] until Switch 2000 
TR>Reset appears.

Press [Enter].

The Confirm RESET? screen appears.

Press [Enter] to confirm. 

If you decide not to reset at this point you may press 
[Left Arrow] to cancel and return to the previous 
screen.

The Switch 2000 TR resets.