Nikon COOLPIX 4500 Maintenance Manual
VAA11901-R.3579.A
- A1・E4500 -
Assembly
Position check
• Move the rack plate to the left.
• The cam groove should be in the position marked white
square shown in Figure 1.
• If not, the cam and the fider lens does not engage.
Therefore, make the cam engage between the finder
lenses as shown in Figure 2 .
• Move the rack plate to the left.
• The cam groove should be in the position marked white
square shown in Figure 1.
• If not, the cam and the fider lens does not engage.
Therefore, make the cam engage between the finder
lenses as shown in Figure 2 .
Rack plate
Cam
Fig. 1
Cam
Finder lens
1. Joint unit
Wire unit
Stand
Lock knob
FPC-A Holder
TB1
Joint unit
FPC-B Holder
• Attach the FPC-B holder with the screw
①
(1.7 x 3.5) and
the screw
②
(1.7 x 1.8).
• Attach the FPC-A holder with the 2 screws
③
(1.7 x 2.5).
• Attach the TB1 plate with the screw
④
(1.7 x 3.5).
• Attach the tripod socket and the lock knob with the 2
screws
screws
⑤
(1.7 x 3.5).
• Pass the 2 pieces of the shield wires through the joint part.
①
②
③
④
⑤
As the connector is wide, bend it
as shown in Figure above and then
pass it through the joint part.
as shown in Figure above and then
pass it through the joint part.
Fig. 2
Note) Be sure to check the position of the rack plate
and the cam before assembling the finder unit and
the lens unit.
and the cam before assembling the finder unit and
the lens unit.
2. Finder uint