Nikon COOLPIX 4500 Maintenance Manual
VAA11901-R.3579.A
- A4・E4500 -
Put it between the eye-
piece unit and the termi-
nal
• Attach the support plate.
• Set the upper lens mold unit and attach the
screw
• Set the upper lens mold unit and attach the
screw
①
(1.7 x 3.5), the screw
②
(1.7 x 5) and
the screw
③
(1.7 x 3.5).
• Pull out the wire from the connector
④
from
the bottom and connect it.
The wires should not be seen when you
look at the unit from the side pointed by an
arrow in Figure 1.
• Apply a piece of tape (black) and a piece of
tape (white). [Refer to Figure 1.]
• Set the eyepiece unit to the lens side lower
cover, and then attach the lens side lower
cover.
• Attach the screw
The wires should not be seen when you
look at the unit from the side pointed by an
arrow in Figure 1.
• Apply a piece of tape (black) and a piece of
tape (white). [Refer to Figure 1.]
• Set the eyepiece unit to the lens side lower
cover, and then attach the lens side lower
cover.
• Attach the screw
⑤
(1.7 x 3.5) and 2 screws
⑥
(1.7 x 3.5).
• Arrange the wires from the terminal unit and
then connect the connector
then connect the connector
⑦ .
• Attach the lens side upper cover with the 2
screws
screws
⑧
(1.7 x 3.5) and the 2 screws
⑨
(1.7
x 3.5).
• Attach the name plate.
• Attach the name plate.
Name plate
Lens side upper cover
Connector ⑦
Lens side lower cover
Support plate
Connector ④
Upper lens
mold unit
①
②
③
⑤
⑥
⑧
Tape (Black)
Tape (White)
[Arrangement of wires from the terminal unit]
Fig. 1
Eye
piece
piece
⑨
5. Lens cover