Sony cyber-shot dsc-t11 User Manual
104
Others
Symptom
Cause
Solution
Your camera does not
work.
work.
• You are not using an “InfoLITHIUM” battery
pack.
• The battery level is low. (The E indicator
appears.)
• The AC Adaptor is not connected securely.
• The camera is not properly installed to the USB
cradle.
p Use an “InfoLITHIUM” battery pack (page 119).
p Charge the battery pack (page 11).
p Connect it securely to the multi connector of your camera and to
a wall outlet (wall socket) (page 15).
p Properly install the camera (page 10).
The power is on, but the
camera does not work.
camera does not work.
• The built-in microcomputer is not working
properly.
p Disconnect, and then, after one minute, reconnect all power
sources and turn on the camera. If this does not work, press the
RESET button on the lower side of the control button using a
fine-tipped object, then turn on the power again. (All the
settings including date and time are cleared.)
RESET button on the lower side of the control button using a
fine-tipped object, then turn on the power again. (All the
settings including date and time are cleared.)
You cannot identify an
indicator on the LCD
screen.
indicator on the LCD
screen.
—
The lens gets fogged.
• Moisture condensation has occurred.
p Turn off the camera and leave for about an hour at room
temperature for the moisture to evaporate before use (page 116).
The camera becomes
warm when you use it for a
while.
warm when you use it for a
while.
—
p This is not a malfunction.