Sony dtc-690 User Manual
44
)
8
1
¡
$
›
•
¶
£
7
Recording
1
Make sure that the TIMER switch is
set to the OFF position, and turn on
the power.
set to the OFF position, and turn on
the power.
2
Insert a cassette and press the
0
OPEN/CLOSE button to load the
cassette (Page 38).
3
Locate the position at which you want
to start recording.
to start recording.
To start recording from the beginning of
the tape, press the
the tape, press the
1 button. (Press
the
1 button again, the "TOP"
indicator will appear at the beginning of
the tape.)
To start from the middle of the tape,
locate the point immediately before the
blank section with the end search
function (Page 54).
the tape.)
To start from the middle of the tape,
locate the point immediately before the
blank section with the end search
function (Page 54).
4
Set the INPUT selector to ANALOG,
OPT or COAXIAL depending upon
your sound source.
OPT or COAXIAL depending upon
your sound source.
5
Press the
¶
REC button.
REC ,
3 and 8 indicators light on the
display, and the deck enters the record-
pause mode. The sampling frequency
to be applied for recording appears.
pause mode. The sampling frequency
to be applied for recording appears.
If the digital copy prohibit signal is
written on the codes of the sound
source, the PROH indicator appears
on the display and signifies that you
cannot record that source with the
digital-to-digital connection. In this
case, use the analog-to-analog
connection.
written on the codes of the sound
source, the PROH indicator appears
on the display and signifies that you
cannot record that source with the
digital-to-digital connection. In this
case, use the analog-to-analog
connection.
6
When recording the analog input
signal, adjust the recording level and
balance with the REC LEVEL controls
respectively (Page 48).
signal, adjust the recording level and
balance with the REC LEVEL controls
respectively (Page 48).
No recording level adjustment is
required when recording the digital
input signal.
required when recording the digital
input signal.
7
Set the REC MODE selector.
When recording in the long play mode
or standard mode, set the REC MODE
selector to the LONG or STANDARD
position respectively (Page 50).
or standard mode, set the REC MODE
selector to the LONG or STANDARD
position respectively (Page 50).
8
When writing start ID automatically
during recording, make sure that the
AUTO indicator is lit.
during recording, make sure that the
AUTO indicator is lit.
If not, press the START ID AUTO button
(Page 62).
(Page 62).
9
When designating the program
number, press the desired numeric
button (Page 72).
number, press the desired numeric
button (Page 72).
When recording from the beginning of
the tape, the program number will be
assigned automatically from 1.
The program number is also written at
the same position as the start ID.
the tape, the program number will be
assigned automatically from 1.
The program number is also written at
the same position as the start ID.
Press the
8
PAUSE or
3
(play) button.
The
8 indicator goes off, and recording
starts.
1
1
3
2
6
7
8
10
2
3
1
¡
4
INPUT
5
¶
REC
6
REC LEVEL
0
1
2
3
4
5
6
7
8
9
10
L R
7
10
8
PAUSE
3
10
5
4
OPT COAXIAL
ANALOG
STANDARD
LONG
REC
MODE
MODE
POWER
\
OFF
PLAY
REC
TIMER
)
OPEN/CLOSE