Sony HKJ-101 User Manual
1-2 (E)
HKJ-101
1-2-1. To install HKJ-101 in J-H1
1.
Remove the six M3 case stopper screws.
2.
Remove the rear panel.
n
Store the removed rear panel in a safe place so as not
to lose it.
n
Store the removed rear panel in a safe place so as not
to lose it.
3.
Insert the connector (CN601) on the DV-29 board into
the connector (CN41) on the CN-2478 board.
n
First, insert the connector (CN401) on the DV-29
board to the hole for i.LINK connector on the IF panel.
Then insert connector (CN601) to the connector on the
CN-2478 board.
the connector (CN41) on the CN-2478 board.
n
First, insert the connector (CN401) on the DV-29
board to the hole for i.LINK connector on the IF panel.
Then insert connector (CN601) to the connector on the
CN-2478 board.
4.
Fix the DV-29 board to the IF panel and to the CN-
2478 board using the supplied screws (PWH2
2478 board using the supplied screws (PWH2
x 5 : 2
screws, PSW2.6
x 5 : 3 screws).
n
When tightening the screws, tighten the screws PWH2
x 5 first of all screws.
When tightening the screws, tighten the screws PWH2
x 5 first of all screws.
Rear panel
M3 case stopper screws
M3 case stopper
screws
screws
DV-29 board
CN-2478 board
PSW2.6
x 5
PSW2.6
x 5
PWH2
x 5
IF panel
CN601
CN41
CN401
5.
Insert the CN-2478 board to the second slot from the
bottom of J-H1.
bottom of J-H1.
6.
Strongly push the connector panel both from the right
and the left sides of the CN-2478 board so that the
connector on the CN-2478 board is securely inserted
into the connector on the MB-993 board.
and the left sides of the CN-2478 board so that the
connector on the CN-2478 board is securely inserted
into the connector on the MB-993 board.
7.
Install the supplied rear panel for J-H1 using the six
M3 case stopper screws.
n
Tighten the screws in the state that the two dowels are
aligned with the holes (a) and (b) on the rear panel as
shown in the figure.
M3 case stopper screws.
n
Tighten the screws in the state that the two dowels are
aligned with the holes (a) and (b) on the rear panel as
shown in the figure.
CN-2478 board
Hole (b)
Hole (a)
Dowel
Dowel
J-H1 rear panel
(Supplied accessory)
(Supplied accessory)
M3 case stopper
screws
screws
M3 case stopper
screws
screws
M3 case stopper
screws
screws