Sony PS-LX300H User Manual

4

If your turntable is equipped with a voltage
selector, be sure to set the selector to your line
voltage.

Carefully, place the platter on the spindle.

Using the ribbon, loop the drive belt around the
motor pully.  After looping the belt, do not forget
to remove the ribbon.

Place the rubber mat on the platter.

Slide the counter weight onto the shaft at the rear
of the tone arm and turn 3 or 4 times in the
direction of the arrow.

Insert the headshell into the front of the tone arm.
Turn the locking collar in the direction of the
arrow until the headshell is secure.

Insert the hinges on the dust cover into the hinge
pockets on the rear of the cabinet.

The phono cables and earth lead come attached to the
rear of the cabinet.

Connect the cable with the red plug to the right
PHONO R input jack on the amplifier and
connect the cable with the white plug to the left
PHONO L input jack.

Connect the earth lead to the earth terminal on the
amplifier.

Be sure to connect the earth lead. Failure to do so will result
in a humming noise from the turntable.

Connect the mains lead to an AC wall outlet after
completing all of the previous connections.
If the power cord plug does not match with your AC
wall outlet, use the supplied plug adaptor.

            / to a wall outlet

PHONO