Sony ta-va777es User Manual

40

The LEVEL menu contains parameters that let you modify
the output level of each speaker and perform a variety of
other adjustments to control the sound mix. The settings
available in this menu effect all the sound fields.

z

p Test Tone

TEST TONE [OFF]

Initial setting : OFF
Lets you turn the test tone on or off.
• When OFF is set, the test tone is not output.
• [AUTO] outputs the test tone from each speaker in

order automatically.

• L (left front), C (center), R (right front), RS (right

surround), LS (left surround), or SW (sub woofer)
outputs the test tone only from the corresponding
speaker.

• The test tone can also be output using the supplied

remote. See “Adjusting the speaker volume” (page 19).

p Front balance

FRONT  L____|____R

Initial setting : center
Lets you adjust the balance between the front left and
right speakers.
• This setting can also be adjusted directly using the

supplied remote. See “Adjusting the speaker volume”
(page 19).

p Rear Balance

REAR  L____|____R

Initial setting : center
Lets you adjust the balance between the rear left and right
speakers.
• This setting can also be adjusted directly using the

supplied remote. See “Adjusting the speaker volume”
(page 19).

p Center level

CENT.LEVEL –XX.XdB

Initial setting : 0 dB
Lets you adjust level of the center speaker.
• The level can be adjusted in 0.5 dB steps from –20 dB to

+10 dB.

• This setting can also be adjusted directly using the

supplied remote. See “Adjusting the speaker volume”
(page 19).

p Rear level

REAR LEVEL –XX.XdB

Initial setting : 0 dB
Lets you adjust level of the rear (left and right) speakers.
• The level can be adjusted in 0.5 dB steps from –20 dB to

+10 dB.

• This setting can also be adjusted directly using the

supplied remote. See “Adjusting the speaker volume”
(page 19).

p Sub woofer level

SUB WOOFER –XX.XdB

Initial setting : 0 dB
Lets you adjust the level of the sub woofer.
• The level can be adjusted in 0.5 dB steps from –20 dB to

+10 dB.

p LFE (Low Frequency Effect) mix level

LFE MIX –XX.XdB

Initial setting : 0 dB
This parameter lets you attenuate the level of the LFE
(Low Frequency Effect) channel output from the sub
woofer without effecting the level of the bass frequencies
sent to the sub woofer from the front, center or rear
channels via the Dolby Digital (AC-3) bass redirection
circuitry.
• The level can be adjusted in 0.5 dB steps from –20 dB to

0 dB (line level). 0 dB outputs the full LFE signal at the
mix level determined by the recording engineer.

• Selecting OFF mutes the sound of the LFE channel from

the sub woofer. However, the low frequency sounds of
the front, center, or rear speakers are output from the
sub woofer according to the settings made for each
speaker in the speaker setup (pages 16~19).