Sony UP-D75 User Manual

Pre

par

at

ion

Connections

7

After connecting a USB connecting cable (not supplied) 
to the printer and the computer, connect the power cord. 
For details about the printer connection, refer to the 
manuals for the computer or other peripheral devices.

Install the printer driver provided with the printer. For 
detailed instructions on how to install the printer driver, 
refer to the Readme.txt file and the install manual 
contained on the CD-ROM disc supplied.

• Follow the connection procedures described in the 

computer manual.

• Make sure that the interface cable is connected 

securely at both ends.

• The printer drive software provided with the printer is 

not suitable for using the printer connected to a 
network.

• Operation of the printer is not guaranteed for 

connection to a USB hub.

• Before connecting the unit using a USB cable (not 

supplied), attach a supplied ferrite core to the end of 
the cable to be connected to the printer for noise 
prevention. For detailed information on how to attach 
the ferrite cores, see “Attaching a ferrite core to a USB 
cable” on page 7.

Before connecting a USB cable (not supplied) to the 
printer, you should attach a supplied ferrite core to its 
cable for noise prevention. To conform to radiation 
standards, attach the supplied ferrite core to the USB 
cable of your device as described below.

Release two stoppers on the ferrite core to open it.

Slip the USB cable through the ferrite core and 
position it at the base of the USB connector to the 
printer.

Close the ferrite core until you hear a click.

When the ferrite core cannot be secure because the USB 
cable is thin, secure it using a tape.

After you connect a USB cable to the printer, it is 
recommended that you secure the USB cable to prevent 
it from being accidentally disonnected using the cable 
stopper.

to (USB) 
connector

USB 
connecting 
cable (not 
supplied)

UP-D75

to - AC IN 
connector

AC power 
cord 
(supplied)

to wall outlet

Computer