Panasonic AG-DVC20P User Manual

Before using

15

If the screen shows the incorrect date/time, then adjust it.
≥Set to Tape Recording Mode.

2] or [1] button in order to select the item to 

3] or [4] button to set the 

desired value.
≥The year will change as follows:

2000, 2001, ..., 2089, 2000, ...

≥The 24-hour clock is used.

Press the [ENTER] button to determine the setting.
≥The clock function starts at [00] seconds.

ª

≥The date and time function are driven by a built-in lithium 

battery.

≥Make sure to check the time before recording because the 

built-in clock is not very accurate.

ª

≥If [

0] or [--] is indicated when the camera is turned on, then 

the built-in lithium battery runs down. Connect the AC adapter 
to the camera or place the battery on the camera, and the 
built-in lithium battery will be recharged. Leave the camera as 
is for approx. 24 hours, and the battery will drive the date and 
time for approx. 6 months. (Even if the [OFF/ON] switch is set 
to [OFF], the battery is still being recharged.)

ª

3] or [4] button in order to select the item to 

2] or [1] button to move the bar indication 

≥In order to adjust the brightness of the viewfinder, close the 

LCD monitor, and the viewfinder will be activated.

≥When the LCD monitor is rotated by 180° towards the lens, 

the brightness of the LCD monitor cannot be adjusted.

≥These settings will not affect the images actually recorded.
ª

≥The [POWER LCD] lamp lights up.
≥If the [POWER LCD] button is pressed, the entire LCD 

monitor will become approx. twice as bright as the normal.

≥Press this button again, and the lamp will go off and the 

brightness will revert back to the original brightness.

≥This will not affect the images to be recorded.
≥If you turn on the camera when the AC adapter is used, the 

[POWER LCD] function will not be activated.

POWER
LCD

DVC20_Eng.book  15 ページ  ２００６年４月６日　木曜日　午前１０時１０分