Panasonic AJ-HD1400P User Manual

36

“_____” indicates the factory setting.

For setting whether to perform the various 
adjustments for the video output signals using this 
VTR or using an external encoder remote controller.
0001

The various adjustments for the video output 
signals are performed using this VTR.

The various adjustments for the video output 
signals are performed using both this VTR and an 
external encoder remote controller.

<Notes>
z For video adjustments, refer to “Video output signal 

adjustments” (page 35).

z If the signals are adjusted with the external 

encoder remote controller, the adjusted values are 
reflected in the setup menu. However, the adjusted 
numerical values will not be stored unless about 1 
minute has elapsed after completion of the 
adjustment operation. If the unit is turned off after 
executing the adjustments with the external 
encoder remote controller, it is necessary to wait 
about 1 minute before turning off the power.

z Settings in this menu are not effective for the 

IEEE1394 digital output.

For selecting what is to be controlled when the  video 
output level is to be adjusted by an external encoder 
remote controller.
0000

The HD video output level can be adjusted.

The SD video output level can be adjusted.

Both the HD and SD video output levels can be 
adjusted.

<Note>
When “CMPST” is selected in menu No. 650 STYLE, 
the unit will be in the same state as when “BOTH” is 
selected, regardless of the settings in this item.

For adjusting the system phase of the HD SDI output 
signals. (in 13.5 ns increments).

– :Phase advances.
+ :Phase delays.

<Notes>
z When menu item No. 25 SYSTEM FREQ is set to 

50i/25P, 25 (HD), 25(SD), 50 (HD) or 50 (SD), the 
setting range is from –1320 -  0 - 1320.

z When menu item No. 25 SYSTEM FREQ is set to 

23/24, the setting range is from –1375 -  0 -  1375.

For adjusting the system phase of the analog 
composite output and SD SDI output signals (total 
variable range of over ±180 degrees).

– :Phase advances.
+ :Phase delays.

For adjusting the system phase of the analog 
composite output signals (in 37 ns increments).

– :Phase advances.
+ :Phase delays.

<Note>
The setting range is –864 to 0 to 864 when 50i/25P, 
25 (HD) or 25 (SD) is selected as the menu item 
No.25 SYSTEM FREQ setting.

For adjusting the system phase of the SD SDI output 
signals (in 37 ns increments).

– :Phase advances.
+ :Phase delays.

<Note>
The setting range is –864 to 0 to 864 when 50i/25P, 
25 (HD) or 25 (SD) is selected as the menu item 
No.25 SYSTEM FREQ setting.

For adjusting the SCH (sub-carrier to horizontal) 
phase of the analog composite output signals (4 
positions in 90-degree increments).
The SC phase changes, and the H phase remains 
unchanged.
0000

For adjusting the SCH (sub-carrier to horizontal) 
phase of the analog composite output signals 
(variable range of over ±45 degrees).
The SC phase changes, and the H phase remains 
unchanged.
A range of ±180 degrees is covered by using this 
setting in combination with item No.18 SCH COAR 
(SD).
0000

For adjusting the phase of the AUDIO output signals 
in relation to the video output signals (in 20.8 µs 
increments).

– :Audio phase against image advance.
+ :Audio phase against image delay.