Panasonic cs-mc120akh User Manual
6
1
2
3
3
■ Setting the batteries
Position
＋ and
− correctly!
Press
with a finger and slide the
back cover to take it off.
Set two alkaline dry batteries (LR03).
Set the back cover as before.
•
This will cause the figures on the display to flash. Set
the clock at this point.
the clock at this point.
•
The address switch is used when two indoor units are to
be installed in a single room.
be installed in a single room.
•
If there is only one indoor unit in the room, it must be set
to “1”.
to “1”.
•
To install two units in a single room, consult the shop
where you bought the air conditioner.
where you bought the air conditioner.
About batteries
•
Always replace two batteries at the same time. Replace
them with new ones of an identical type.
them with new ones of an identical type.
•
Do not use manganese dry batteries since their use may
cause a malfunction.
cause a malfunction.
•
If you are not going to use the air conditioner for a long
period, take out all the batteries.
period, take out all the batteries.
•
Batteries should last for about a year under normal
conditions. When you find the displays unclear and
signal communication often failing, replace them with
new ones.
conditions. When you find the displays unclear and
signal communication often failing, replace them with
new ones.
•
Batteries may be exhausted even before the
recommended date of consumption printed on them, if
the air conditioner was manufactured many months ago.
recommended date of consumption printed on them, if
the air conditioner was manufactured many months ago.
•
Never try to recharge the batteries.
2
1
■ Operating the remote controller
Choose a place from where the signals
reach the unit.
reach the unit.
Fix the holder to a wall, a pillar, etc. with the
screws supplied with the holder.
screws supplied with the holder.
Fit the claw of the holder into the bottom of
the remote controller, and push the remote
controller onto the wall.
the remote controller, and push the remote
controller onto the wall.
About the remote controller
•
Never expose the remote controller to direct sunlight.
•
Dust on the signal transmitter or receiver will reduce
the sensitivity. Wipe off dust with soft cloth.
the sensitivity. Wipe off dust with soft cloth.
•
Signal communication may be disabled if an electronic-
starter-type fluorescent lamp (such as inverter-type
lamps) is in the room. Consult the shop if that is the
case.
starter-type fluorescent lamp (such as inverter-type
lamps) is in the room. Consult the shop if that is the
case.
•
If the remote control signals happen to operate another
appliance, move that appliance to somewhere else, or
consult the shop.
appliance, move that appliance to somewhere else, or
consult the shop.
•
To use the remote controller, aim the transmitter at the indoor
unit. If there is anything to block signals between the unit and
the remote controller, such as a curtain, the unit will not
operate.
unit. If there is anything to block signals between the unit and
the remote controller, such as a curtain, the unit will not
operate.
•
Do not drop the remote controller. Do not get it wet.
•
The maximum distance for communication is about 7 m.
■ To fix the remote controller holder
on the wall (option)
Receiver
Address switch
3
Remote controller
1
2
3
②
Push.
①
Set.
Remote
controller
holder
controller
holder
•
To remove, pull it upwards.
Preparation Before Operation
ATTENTION
ATTENTION