Panasonic cs-mc120akh User Manual
8
運転
タイマ
おそうじ
DRY/COOL/FAN Mode Operation
The air conditioner operates with the settings of your
choice.
From the next time on, the air conditioner will operate
with the same settings.
choice.
From the next time on, the air conditioner will operate
with the same settings.
1
2
Press
MODE
and select a mode.
•
Each pressing of the button advances the mode setting
in sequence.
in sequence.
Press
OFF/ON
.
Then OPERATION lamp
lights up.
lights up.
■ To stop:
Press
OFF/ON
once again.
Then OPERATION lamp goes off.
■ To change the temperature setting:
■ To change the air flow rate setting:
Press
to raise the temperature and press
to lower the temperature.
Press
FAN SPEED
.
•
At smaller air flow rates, the cooling effect is also smaller.
■ To change the air flow direction:
(See page 8.)
DRY or FAN mode
COOL mode
The temperature
setting is not
variable.
setting is not
variable.
C
Set to the temperature
you like.
you like.
DRY mode
COOL or FAN mode
Five levels of air flow rate setting from “
” to
“
” plus “
” are available.
Display
The air flow
rate setting
is not variable.
rate setting
is not variable.
Display
Notes on DRY mode operation
•
This operation dehumidifies the indoor air when it is humid.
Notes on flap angles
•
The diffuser is kept open in
DRY,COOL or FAN mode.
Adjusting the
horizontal blade (flap)
horizontal blade (flap)
You can adjust the air flow direction to increase your
comfort.
comfort.
Press
SWING
.
•
Every time the button is pressed, “
” appears or
disappears.
.......
The flap automatically
swings up and down.
swings up and down.
No display
.......
To stop the flap at an
angle you like, press
angle you like, press
SWING
.
DRY
•
Unless [SWING] is selected, you should set the flap at
a near-horizontal angle in COOL or DRY mode to
obtain the best performance.
a near-horizontal angle in COOL or DRY mode to
obtain the best performance.
•
In DRY mode, if the flap is fixed at a upward position,
the flap automatically moves in about 60 minutes to
prevent condensation on it.
the flap automatically moves in about 60 minutes to
prevent condensation on it.
NOTE
•
Always use a remote controller to adjust the flap angle.
If you attempt to move it forcibly with hand when it is
swinging, the mechanism may be broken.
swinging, the mechanism may be broken.
•
Be careful when adjusting the louvre. Inside the air
outlet, a fan is rotating at a high speed.
Adjusting the louvre
Hold the knob and move the louvre.
(You will find a knob on the left-end and the right-end blades.)
(You will find a knob on the left-end and the right-end blades.)
ATTENTION
Adjusting the Air Flow Direction
COOL
FAN
FAN
FILTER
POWER
TIMER
OFF/ON
Display