Panasonic PT-AR100U User Manual

66 - ENGLISH

 

z

• 

 

If the trigger input signal from the external device is 

changed from 0 V to 12 V, the projector power will be 

switched on. And if it is changed from 12 V to 0 V, the 

power will be switched off.
[BLANK]

• 

 

If the trigger input signal from the external device is 

changed from 0 V to 12 V, the screen will go blank. And 

if it is changed from 12 V to 0 V, the [BLANK] setting 
will be released.

The delay time can be set to 2, 4, 6, 8, 10, 20, and 

 

z

30 seconds.

It is possible to delay the trigger output signal (12 V) 

 

z

by the amount of time set. (Only available if trigger 

output item is selected.)

E.g.)  Select [SELECT 4:3 ASPECT] of the trigger output 

function and set the delay time to 10 seconds.

 

  Set the [ASPECT] in the [POSITION] menu to [4:3], 

and 12V is output from the trigger port after 10 
seconds.

You should not use trigger terminal output as the power 

 

z

source for other devices.

The projector will not accept trigger input while preparing 

 

z

to project after the power has been switched on and 

while preparing to shutdown after projection. Input trigger 

signals after projection starts or after entering standby 

mode.

12 V cannot be output from the trigger terminal when the 

 

z

projector is in standby mode.

Set to [ON] when using at locations between 1400 m 

and 2 700 m above sea level.

When using at an altitude of less 

than 1 400 m above sea level

When using at high altitudes 

(between 1 400 m and 2 700 m 

above sea level)

The fan rotation and operating noise increases if set to 

 

z

[ON].

Switch the lamp intensity according to the usage 

environment of the projector and its intended use.

When higher luminance is 

required

When lower luminance is 

sufficient

The brightness in the [ECO] settings is lowered 

 

z

enabling saving power and reducing operating noise. It 

is recommended that you use the [ECO] setting when 

viewing in a place where natural light is blocked and 

there is no artificial light.
When no input signal is detected, the function is disabled.

 

z