Panasonic PT-AR100U User Manual
[OPTION] menu
66 - ENGLISH
Settings
Input
z
[POWER ON/OFF]
[BLANK]
[POWER ON/OFF]
•
If the trigger input signal from the external device is
changed from 0 V to 12 V, the projector power will be
switched on. And if it is changed from 12 V to 0 V, the
power will be switched off.
[BLANK]
[BLANK]
•
If the trigger input signal from the external device is
changed from 0 V to 12 V, the screen will go blank. And
if it is changed from 12 V to 0 V, the [BLANK] setting
will be released.
will be released.
Press the ▲▼◄► buttons to move the
3)
cursor to [DELAY TIME]
Press the ◄► buttons to set the delay
Press the ◄► buttons to set the delay
4)
time for the trigger output signal
The delay time can be set to 2, 4, 6, 8, 10, 20, and
z
30 seconds.
It is possible to delay the trigger output signal (12 V)
z
by the amount of time set. (Only available if trigger
output item is selected.)
E.g.) Select [SELECT 4:3 ASPECT] of the trigger output
function and set the delay time to 10 seconds.
Set the [ASPECT] in the [POSITION] menu to [4:3],
and 12V is output from the trigger port after 10
seconds.
seconds.
Note
You should not use trigger terminal output as the power
z
source for other devices.
The projector will not accept trigger input while preparing
z
to project after the power has been switched on and
while preparing to shutdown after projection. Input trigger
signals after projection starts or after entering standby
mode.
12 V cannot be output from the trigger terminal when the
z
projector is in standby mode.
[HIGH ALTITUDE MODE]
Set to [ON] when using at locations between 1400 m
and 2 700 m above sea level.
Switch settings
Switch settings
[OFF]
When using at an altitude of less
than 1 400 m above sea level
[ON]
When using at high altitudes
(between 1 400 m and 2 700 m
above sea level)
Note
The fan rotation and operating noise increases if set to
z
[ON].
[LAMP POWER]
Switch the lamp intensity according to the usage
environment of the projector and its intended use.
Switch settings
Switch settings
[NORMAL]
When higher luminance is
required
[ECO]
When lower luminance is
sufficient
Note
The brightness in the [ECO] settings is lowered
z
enabling saving power and reducing operating noise. It
is recommended that you use the [ECO] setting when
viewing in a place where natural light is blocked and
there is no artificial light.
When no input signal is detected, the function is disabled.
When no input signal is detected, the function is disabled.
z