Panasonic UB-7320 User Manual

English

Treat problems according to the information given in the table below. If problems still persist, call your dealer for 
service.

Power switch is on but the 
indicator is off.

Check that the power plug is securely plugged in.
(If the indicator still does not light, turn the power off and on again.)

–

Copied copy paper will not 
come out.

The unit is out of copy paper. (The Error Indicator flashes “

”.)

Load new paper.

The printer door is open. (The Error Indicator flashes “

”.)

Close the printer door firmly until a click is heard.

Paper is jammed in the printer.

Remove the jammed paper and cut off the wrinkled portion, then 
load paper again.

The paper feed roller is dirty.

Open the printer door and wipe the paper feed roller to clean it.

Nothing is printed on the 
paper or copies are faint or 
blurred.

Confirm the paper is loaded correctly, smooth side face up.

The writing on the screen is too thin or light.

Make thicker, darker lines or change to a new marker.

–

The printer door is slightly open.

Close the printer door firmly, using two hands until a click is heard.

Black streaks or blank 
(unprinted) spots appear on 
the copy (copy paper is dirty).

The printer head or paper feed roller is dirty.

Open the printer door and clean any dirt off the printer head and 
paper feed roller.

A black or white horizontal 
line appears, or the page 
prints in black or blank.

The unit is in strong sunlight or strong lighting.

Change the direction of the screen or block the light.

–

The screen does not 
advance when the Copy, 
Advance or Reverse Key is 
pressed.

Static electricity was generated when the screen film was wiped.

Turn off the power and slowly move the screen by hand.

–

When connecting a USB 
cable after installing the 
driver, the warning message 
is displayed to require the 
Panaboard UB5-7 Driver 
Disk.

The necessary file is not found in Windows 98.

Click the location’s box and select the pass 
“UB5-7\UsbDrv\Win98-Me” in the pull down menu.

–

The software installed before 
is deleted from the Programs 
menu or cannot be used after 
installing the Panasonic-
DMS.

After the existing Panasonic-DMS software is uninstalled, the new 
Panasonic-DMS is installed.

Install the new Panasonic-DMS again as follows.
1. Uninstall the current Panasonic-DMS.
2. Install the old Panasonic-DMS.
3. Install the new Panasonic-DMS in the same folder with the old one.

16-17