Panasonic WJ-HD200 User Manual

36

• VMD should be used when the input to the unit is

from an ordinary camera. Select [OFF] to avoid use-
less VMD when a video multiplexer or combination
camera supplies the input to the unit.

• Set ALARM SUSPEND to ON when you do not want

VMD to be activated during the VMD setup.

• There may be cases where VMD does not suffi-

ciently detect changes, since it detects the
changes in luminance.

• The detection area may include areas slightly out-

side the border.

• The buzzer will beep if detection takes place during

the area setup.

4. Set the upper-left end of the detection area. Move the

asterisk to the right or left with the JogDial, and up or
down by pressing the [D] or [C] button.

5. Press the JogDial to enter the upper-left end of the

detection area. The asterisk position is highlighted.

6. Set the bottom-right end of the detection area similar to

steps 3 and 4 above.

7. Press the JogDial. The area is highlighted.

Up to 4 areas can be selected. These may partially
overlap. Repeat steps 3 to 6 to select more areas. To
deselect an area, move the cursor to the upper-left end
of the area, and press the JogDial.

■ Communication Setup

Communication parameters are set to match those of the
connected devices and the system configuration. The serial
port setup and network setup are made.

■ Serial Port Setup 

The SERIAL PORT SETUP menu appears when it is select-
ed in the COMMUNICATION SETUP menu.

Note: Parameters marked with * on the following pages are

default settings applicable to RS-232C.

● Protocol (PROTOCOL)

1. Move the cursor to PROTOCOL with the [D] or [C] but-

ton.

2. Select a suitable protocol with the JogDial, and press

the JogDial. 
The default is PS

•

DATA.

DATA: Select when the communication chain uses

the PS

•

DATA protocol.

This selection enables the DATA terminal on the
rear panel for communication.

RS-232C: Select when a protocol other than PS

•

DATA

is used. 
This selection enables the RS-232C terminal on the
rear panel for communication.

Note: Parallel use of the DATA and RS-232C terminals

is not possible.

PUSH

  •  

PAUSE

/

/

SET

REW/FF

/

STEP

/

q

w

e

r

O

O

O