Panasonic WJ-HD200 사용자 설명서
36
Notes:
• VMD should be used when the input to the unit is
from an ordinary camera. Select [OFF] to avoid use-
less VMD when a video multiplexer or combination
camera supplies the input to the unit.
less VMD when a video multiplexer or combination
camera supplies the input to the unit.
• Set ALARM SUSPEND to ON when you do not want
VMD to be activated during the VMD setup.
• There may be cases where VMD does not suffi-
ciently detect changes, since it detects the
changes in luminance.
changes in luminance.
• The detection area may include areas slightly out-
side the border.
• The buzzer will beep if detection takes place during
the area setup.
4. Set the upper-left end of the detection area. Move the
asterisk to the right or left with the JogDial, and up or
down by pressing the [D] or [C] button.
down by pressing the [D] or [C] button.
5. Press the JogDial to enter the upper-left end of the
detection area. The asterisk position is highlighted.
6. Set the bottom-right end of the detection area similar to
steps 3 and 4 above.
7. Press the JogDial. The area is highlighted.
Up to 4 areas can be selected. These may partially
overlap. Repeat steps 3 to 6 to select more areas. To
deselect an area, move the cursor to the upper-left end
of the area, and press the JogDial.
overlap. Repeat steps 3 to 6 to select more areas. To
deselect an area, move the cursor to the upper-left end
of the area, and press the JogDial.
■ Communication Setup
(COMMUNICATION SETUP)
Communication parameters are set to match those of the
connected devices and the system configuration. The serial
port setup and network setup are made.
connected devices and the system configuration. The serial
port setup and network setup are made.
■ Serial Port Setup
(SERIAL PORT SETUP)
The SERIAL PORT SETUP menu appears when it is select-
ed in the COMMUNICATION SETUP menu.
ed in the COMMUNICATION SETUP menu.
Note: Parameters marked with * on the following pages are
default settings applicable to RS-232C.
● Protocol (PROTOCOL)
1. Move the cursor to PROTOCOL with the [D] or [C] but-
ton.
2. Select a suitable protocol with the JogDial, and press
the JogDial.
The default is PS
The default is PS
•
DATA.
PS
•
DATA: Select when the communication chain uses
the PS
•
DATA protocol.
This selection enables the DATA terminal on the
rear panel for communication.
rear panel for communication.
RS-232C: Select when a protocol other than PS
•
DATA
is used.
This selection enables the RS-232C terminal on the
rear panel for communication.
This selection enables the RS-232C terminal on the
rear panel for communication.
Note: Parallel use of the DATA and RS-232C terminals
is not possible.
*
CAM1
PUSH
•
PAUSE
/
/
SET
REW/FF
/
STEP
/
q
w
e
r
SERIAL PORT SETUP
PROTOCOL PS•DATA
BAUD RATE 9600
DATA BIT 8
PARITY CHECK NONE
STOP BIT 1
WAIT TIME OFF
CTL-UNIT ADDR 1
SYS-UNIT ADDR 1
ALARM DATA 1S
CAM NO.SETUP
BAUD RATE 9600
DATA BIT 8
PARITY CHECK NONE
STOP BIT 1
WAIT TIME OFF
CTL-UNIT ADDR 1
SYS-UNIT ADDR 1
ALARM DATA 1S
CAM NO.SETUP
O
COMMUNICATION SETUP
SERIAL PORT SETUP
O
NETWORK SETUP
O