Panasonic WV-BP120 User Manual
(3) Put the heat shrinkable tubes or equivalent tubes
on the inner cables of the iris control cable.
(4) Solder the inner cable of the iris control cable at
the pin-plug block according to the following pin
assignment and cover the heat shrinkable tubes or
equivalent tubes over the soldered area and heat
on the tubes to shrink them.
Pin 1 : Power source : +9V DC, 50mA Max.
Pin 2 : Not used
Pin 3 : Video signal : 0.7 V[p-p]/40 k
assignment and cover the heat shrinkable tubes or
equivalent tubes over the soldered area and heat
on the tubes to shrink them.
Pin 1 : Power source : +9V DC, 50mA Max.
Pin 2 : Not used
Pin 3 : Video signal : 0.7 V[p-p]/40 k
Ω
Pin 4 : Shield, ground
(Set the Lens Selection switch to the VIDEO
Position)
(Set the Lens Selection switch to the VIDEO
Position)
-14-
2. Installation of Auto Iris Lens Connector
When you use a auto iris lens other than listed on
pages 10, 11 and 12, for example a video servo ALC
lens, install the lens connector (YFE4191J100) coming
with the camera as follows.
pages 10, 11 and 12, for example a video servo ALC
lens, install the lens connector (YFE4191J100) coming
with the camera as follows.
The following installation should be made by quali-
fied service personnel or system installers.
fied service personnel or system installers.
(1) Cut off the iris control cable at the edge of lens
connector and then cut off the outer cable cover
as shown in the diagram.
as shown in the diagram.
Iris Control Cable
Cut Off
Lens Connector
Iris Control Cable
Approximately 8 mm (5/16")
(2) Cut off the inner cable covers of the iris control
cable as shown in the diagram.
Approximately 6 mm (1/4")
Pin 3
Pin 1
Rib
Pin 4
Pin 2