Panasonic WV-BP120 User Manual

(5) Both the connector cover and connector should

be positioned to interlock.

Cut off the rib on the connector, when the iris
control cable is too thick and the connector
cover and connector can not be interlocked.

-15-

Always set the Flange-back adjusting ring to fully
clockwise (C-mount side) by loosing screws on the
ring before mounting the lens, otherwise the inner
glass and CCD image sensor could be damaged
by the lens.

(1) Mount the lens by turning it clockwise onto the

lens mount of the camera.

(2) Connect the lens cable to the Auto Iris Lens

Connector on the camera when an auto iris lens is
used.

(3) Set the Lens Selection Switch to the proper posi-

tion as follows.

Connector
Cover

Heat
Shrinkable
Tubes

Automatic
Iris Lens

Iris Control
Cable

Connector

When you use the lens other than listed on pages 10,
11, 12 and 13, lens mount should be C-mount or spe-
cial C-mount (CS-mount 1"-32UN) and lens weight
should be less than 450

g (0.99 lbs.). If not, both the

lens and camera should be secured.
The protrusion of the rear of the lens should be as
shown below.

C-mount : Less than 11.5 mm (7/16")

CS-mount : Less than 7.2 mm (1/4")