FIC a440 Service Manual
Maintenance & Disassembly
FIC A440 Series Service Manual
5-13
5.5.8 Removing the Charger Board
The procedures for removing and replacing the I/O + Charger board and DC/DC board are as
follows:
follows:
Figure 5-11
I/O Board Assembly
1. Before removing the I/O + charger board, you need first to disassemble the glidepad,
keyboard, heat plate, hard disk, LCD panel, upper casing, and audio board.
2. The I/O board is plugged into the middle of the motherboard. The I/O board is also where
the FDD cable, hard disk, and audio board are attached. Remove all cables connected to
it.
it.
3. There are three screws and one hex bolt securing the I/O board (see Figure 5-11). Remove
the screws and slowly pull out the I/O board.
5.5.9 Removing the CD-ROM Module
The procedures for removing and replacing the CD-ROM module is as follows:
1. Before removing the CD-ROM module, you need first to disassemble the glidepad,
1. Before removing the CD-ROM module, you need first to disassemble the glidepad,
keyboard, heat plate, hard disk, LCD panel, and upper casing. The CD-ROM module is
found at the upper left side of the base unit.
found at the upper left side of the base unit.
2. To remove the CD-ROM module, remove the screws securing the CD-ROM bracket and
pull out the drive from the connector.
3. Slowly slide the CD-ROM module out of the base unit.
4. To replace the CD-ROM, remove the metal bracket around it.
I/O + Charger
Board
Board
Screws
Hex Bolt