Panasonic wv-cu360 User Manual
8
■
Rear View
DC 9V IN
DATA
MODE
RISK OF ELECTRIC
SHOCK. DO NOT OPEN
SHOCK. DO NOT OPEN
RISQUE DE CHOCS ELECTROUES
NE PAS OUVRIR
0
9
8
7
6
5
4
3
2
1
#6
#7
#5
CONTROLLER No.
#4
#3
#3
Controller Number switch (CONTROLLER No.)
This switch is used to set a controller number for the
System Controller to identify it in a system comprising
multiple System Controllers (See page 9). A system
may comprise up to four controllers.
System Controller to identify it in a system comprising
multiple System Controllers (See page 9). A system
may comprise up to four controllers.
Note:
Keep the DC plug of the supplied AC adapter
disconnected from DC 9V Input Jack during con-
troller number setting.
troller number setting.
#4
Mode Selection switches (MODE)
The DIP switches are used to change the internal set-
tings of the System Controller (see page 9).
tings of the System Controller (see page 9).
#5
Data Ports (DATA)
These ports are used to exchange control data with the
WJ-MP204 Data Multiplex Unit via the supplied RS-485
cable.
WJ-MP204 Data Multiplex Unit via the supplied RS-485
cable.
#6
DC 9V Input Jack (DC 9V IN)
Jack for the DC plug of the supplied AC adapter.
#7
Clamper
The clamp fastens the power cord to the AC adapter.
Refer to the Operating Instructions of the Data Multiplex
Unit WJ-MP204 for further details.
Unit WJ-MP204 for further details.
NOTE