DELL inspiron 4100 User Manual

Removing and Replacing Parts: Dell Inspiron 4100

The memory module must be inserted at a 45-degree angle to avoid damaging the 

connector. 

2.  Align the notch in the memory module with the slot in the center of the socket. 

3.  Slide the edge connector of the module firmly into the socket at a 45- degree angle, and rotate 

the module down until you hear a click. If you do not hear the click, remove the module and 

reinstall it. 

4.  Replace the cover and tighten the two captive screws. 

You must remove the Mini PCI card before the system board can be removed.

Disconnect the computer and any attached devices from electrical outlets, and 

remove any installed batteries. 

To avoid ESD, ground yourself by using a wrist grounding strap or by touching an 

unpainted metal surface on the computer. 

procedure. 

1.  Remove the memory module cover. 

2.  Disconnect the Mini PCI card from the antenna cables. 

3.  To release a Mini PCI card from its socket, spread apart the metal securing tabs until the card 

pops up slightly. 

4.  Lift the Mini PCI card out of its connector. 

file:///I|/SERVICE%20MANUALS/DELL%20MANUALS/LA...20ok/Inspiron/4100/4100_SERVICE_MAN/remove.htm (17 of 52)6/21/2004 1:02:31 AM