JVC dr-m10s User Manual
Masterpage:Right-No-Heading
EN
59
Filename [DR-M10SE_08Recording.fm]
Page 59
February 12, 2004 5:15 pm
F
Enter the recording stop time.
Press w e to select “STOP”, then press rt repeatedly to
set the desired stop time.
set the desired stop time.
● Each press of rt advances/goes back the stop time in 1-min.
increments.
● To advance/go back the stop time in 30-min. increments, press
and hold rt.
G
Enter the channel position.
Press w e to select “TV PROG”, then press rt
repeatedly to select the desired channel.
repeatedly to select the desired channel.
H
Set “DAILY/WEEKLY” option.
Refer to step
● It is necessary to set “DAILY/WEEKLY” option for On-Disc
Timer Programming. (
I
Set the other recording options as required.
Refer to step
● You can select XP, SP, LP, EP or FR480 mode for “REC
MODE”. You cannot select FR (JUST), FR60–FR360 and
FR420.
FR420.
J
Access the confirmation screen.
Press ENTER.
K
Complete timer programming.
Press ENTER.
To timer-record the programme with
the programmed disc
the programmed disc
A
Load the disc.
A Press x to open the disc tray.
B Place the programmed disc on the disc tray.
● For details, refer to “Placing a Disc” (
C Press x to close the disc tray.
B
Engage the unit’s timer mode.
Press DVD 1. The unit turns off and “
” appears
on the front display panel.
● To disengage the timer mode, press DVD 1 again.
NOTES:
● Even if On-Disc Timer Programming is overlapping with other
timer programming, any caution message does not appear. In
such a case, recording will be executed in the descending
order of the recording start time of the programme.
such a case, recording will be executed in the descending
order of the recording start time of the programme.
● On-Disc Timer Programming is not possible on a DVD-RW
disc formatted in video mode. (
● The information of a programme recorded with On-Disc Timer
Programming is not stored in the library. (
● The play list is not created for the programmes recorded with
On-Disc Timer Programming. (
● S
HOW
V
IEW
Timer Programming is not possible on the discs
used exclusively for On-Disc Timer Programming.
● Manual Timer Programming is not possible on the On-Disc
Timer Programmed disc. (
● Basic Recording is not possible on the On-Disc Timer
Programmed disc. (
● The On-Disc Timer Programming function does not work on
the unit form other manufactures even if the On-Disc Timer
Programmed disc is loaded.
Programmed disc is loaded.
● The beginning of a programme may not be recorded. Also, if
the 1st programme’s recording stop time and the 2nd
programme’s recording start time is the same, the ending of the
1st programme may not be recorded.
programme’s recording start time is the same, the ending of the
1st programme may not be recorded.
● If there is a power cut while recording, the recordings before
the power cut are not guaranteed.
Satellite Receiver Users
To timer-record a satellite broadcast using the On-Disc Timer
Programming function:
A Perform “Satellite Receiver Control Setting” on page 26.
B Perform “On-Disc Timer Programming”. In step I, you
Programming function:
A Perform “Satellite Receiver Control Setting” on page 26.
B Perform “On-Disc Timer Programming”. In step I, you
cannot set “VPS/PDC” to “ON”.
C Leave the satellite receiver’s power on.
DR-M10SE_01.book Page 59 Thursday, February 12, 2004 9:08 PM