Siemens MC35 User Manual
AT Command Set
MC35_ATC_01_V05.00
Page 32 of 256
15.07.2002
2.18 ATQ Set result code presentation mode
Write command
ATQ[<n>]
Response
Specifies whether or not the TA transmits any result code to the TE. Information
text transmitted in response is not affected by this setting.
If <n>=0:
OK
If <n>=1:
(none)
text transmitted in response is not affected by this setting.
If <n>=0:
OK
If <n>=1:
(none)
Parameter
<n>
0 DCE transmits result code
1 Result codes are suppressed and not transmitted
Reference
V.25ter
Note
2.19 ATP Select pulse dialling
Execute command
ATP
Response
OK
Reference
V.25ter
Note
No effect for GSM
2.20 ATS0 Set number of rings before automatically answering the call
Read command
ATS0?
Response
<n> OK
Write command
ATS0=<n>
Specifies whether or not the TA will accept an incoming data / fax call without
user intervention. <n> determines the number of rings to wait before the TA will
automatically answer.
user intervention. <n> determines the number of rings to wait before the TA will
automatically answer.
Response
OK
Parameter
<n> 000
disables automatic answer mode
001-255 enables automatic answering after specified number of rings
Reference
V.25ter
Note
· Auto-answer mode is only applicable to data or fax calls.
· If <n> is set too high, the calling party may hang up before the call can be
automatically answered.
· The correlation between ATS7 and ATS0 is important.
Example: Call setup may fail if ATS0=20 and ATS7=30.