Yamaha digital mixing studio 01x User Manual

01X Owner’s Manual

Overview of the 01X

Before Using

Basics Section

Appendix

Getting Started

Reference

Stereo input channels 1/2

These are stereo input channels used mainly for inputting

the return signal from internal effects 1/2. However, the

input signal assignment can be changed in the input patch

section, allowing these to be used as additional input chan-

nels.

The level (return level) of the stereo input channels can be

controlled by using the channel faders 7 (for Effect 1) and

8 (for Effect 2) when [MASTER] layer in the MIXER/

LAYER is seleced in Internal mode.

● Differences from input channels

• Stereo

• No dynamics processor

• No direct output

• When using an internal effect via the Aux Send, do NOT turn up

the send level to the corresponding AUX bus for the channel to

which the effect return signal is routed. Doing so will result in

loud feedback, and may damage your equipment. For example,

when the 01X is in the default condition, AUX 3 is routed to the

input of internal effect 1, and the L/R signals of the ST IN chan-

nel 1 are routed to the output. If you turn up the send level of ST

IN channel 1 to AUX 3, a feedback loop is created.

• Since stereo input channels 1/2 are stereo, adjacent odd-numbered/

even-numbered signals will be assigned to them when MIC/LINE

inputs are selected as the input signals. Also, if DIGITAL STEREO IN

is selected, both L and R signals will be assigned.

Digital cascade connection

The input signal from the rear panel DIGITAL STEREO

IN connector can be cascade-connected directly to the ste-

reo bus, instead of being routed through the input patch

section and patched to an input channel. This is convenient

when you want to link an external digital mixer or similar

device with the mixer section of the 01X. (Refer to the

“Digital In Stereo Bus Cascade” on page 93.)

Oscillator

The 01X contains an oscillator that allows you to select

either sine wave (100Hz, 1kHz, 10kHz) or white noise.

The oscillator signal can be sent to rec bus, AUX buses 1

through 4, or the stereo bus. (Refer to the “Oscillator” on

page 93.)

ST IN 1(...2)

RECBUS (BUS) L

RECBUS (BUS) R

STEREO (STEREO BUS) L

STEREO (STEREO BUS) R

AUX 1

AUX 2

AUX 3 (FX1)

AUX 4 (FX2)

PAN

Stereo in X 2
(96kHz/88.2kHz: X 1)

4BAND EQ

ATT

INPUT

SELECT (INPUT PATCH)

ATT

METER

LEVEL

AUX

PRE/POST