Yamaha digital mixing studio 01x User Manual

01X Owner’s Manual

Overview of the 01X

Before Using

Basics Section

Appendix

Getting Started

Reference

Monitor output/headphone output

For monitoring purposes, the 01X provides MONITOR

OUT jacks and a PHONES jack. The MONITOR OUT

jacks and PHONES jack always output the same signal,

and is linked to the level adjustment. You can monitor the

output directly (monitor cascade) through the connected

speaker system/headphones (according to the [MONITOR

A/B] setting), if the stereo master output of the DAW is set

to the last two available channels (the last two numbered

channels specified with mLAN Auto Connector; refer to

the separate Installation Guide). (Refer to “Monitor” on

page 96.)

Internal effects 1/2

The two built-in effect units deliver a wide variety of

effects including spatial-type effects such as reverb and

delay, modulation type effects such as chorus and flanger,

and guitar-type effects such as distortion and amp simula-

tion. These effects can be used via Aux send (the level cor-

responds to the master level of the stereo input channels),

or inserted into a desired channel.

• If 88.2kHz/96kHz operation is enabled, only one internal effect block

is available (Effect 1/Aux 3).

• For details about each Effect Type, refer to page 125; for details

about each Effect Parameter, refer to page 126.

• For an application example showing how to use the effects, see page

57.

(MONITOR CASCADE)

STEREO R

STEREO L

(MONITOR IN)

mLAN STEREO IN

(MONITOR IN)

mLAN STEREO IN

PHONES

-10dBV

MONITOR OUT

Min Max

BAL

MONITOR

A/B

(Mix Balance)

MONITOR/

PHONES Knob

EFFECT 1

AUX3

INSERT SEND

SELECT

EFFECT

EFFECT 2

AUX4

INSERT SEND

SELECT

EFFECT

INPUT

SELECT (INPUT PATCH)

EFFECT2 is available in
48kHz/44.1kHz mode only.

*1 Wordclock 96kHz/88.2kHz : 16
*3 Studio Manager only

FX1

FX2

METER

(FX)

METER

(FX)